Frequently asked questions about the shop
URETEK can lift floors with millimeter precision. This is possible thanks to the extremely fast reaction time of the URETEK expansion resin. By continuously monitoring the injection process with a highly sensitive laser and drawing on our technicians’ extensive experience, we achieve an extremely reliable result.
URETEK expansion resin has an extremely short reaction time. Our material reaches 90% of its final strength in just 15 minutes. As a result, the treated floors can bear loads almost immediately.
It remains easy to work with for a few minutes, doesn’t it? Although URETEK’s expansion resin belongs to the polyurethane family, it is in no way comparable to the PUR foams available at home improvement stores. Our resins have been specially developed and modified for URETEK processes. Each URETEK resin is characterized by its unique composition.
With URETEK’s methods, no cutting or demolition work is required. To correct sunken floors and realign foundations, we drill just a few holes with a maximum diameter of 12 mm into the ground. In some cases, we even work exclusively from the outside. We then inject the high-performance expansion resin into the underlying soil. Typically, this work can be completed in a single day, and residential and commercial spaces can continue to be used normally. Furthermore, the floor can bear full loads again almost immediately after the work is completed. The URETEK team has extensive experience with this type of work, and all employees have been trained to work carefully and leave the premises clean upon completion of the work.
No. The flexural strength of a floating floor is not sufficient to lift the floor evenly and uniformly. The expansion force of our synthetic resins would cause local unevenness or, worse yet, the floor could even break.
No. The answer is the same as for floating floors. The bending strength of a wood floor is not sufficient to lift the floor evenly and uniformly. The expansion force of our synthetic resins would cause local unevenness or, worse yet, the floor could even break.
If the tile floor is installed on a concrete subfloor that is at least 8 to 10 cm thick, our URETEK FloorLift® method is highly likely to resolve the issue. Our technical consultants can assess on-site whether we can help you.
The thickness of the concrete floor is more important than the presence or absence of reinforcement. Among other things, we have raised floors that were only 8 cm thick and used a metal mesh as reinforcement.
Over the years, we have renovated thousands of square meters of asphalt floors. Here, too, the flexural strength must be sufficient. To ensure an even and uniform “raising” of the floor, it must be sufficiently durable. Our technical consultants would be happy to assess the situation on site.
In principle, there are options available in this case as well. It is important to know the thickness of the underlying peat layer. This can be determined through a soil analysis. We would be happy to assist you with this.
A floor that rests “freely” on the piles can be raised. In this context, “freely” means that the floor or the foundation beam is not structurally connected to the pile by reinforcing steel. If this is the case, our method is not suitable.
The expansion force of our resin is very high and can reach up to 10,000 kPa (100 bar), depending on the resistance encountered during expansion. Therefore, localized loads from heavily loaded shelves do not pose a problem for the URETEK methods.
With current technology, we can reach depths of up to about 6 meters.
In principle, there are options available in this case as well. It is important to know the thickness of the underlying peat layer. This can be determined through a soil analysis. We would be happy to assist you with this.
We had our resins thoroughly tested by the renowned Hygiene Institute in Gelsenkirchen. The study examined the sensitivity of plants, earthworms, and bacteria when they came into contact with our foam. The environmental impact is minimal. See also Environmental Safety.
If circumstances require it, we can adjust our working hours. For example, we can also work at night or on weekends. One of the main advantages of the URETEK method is that there is no need to clear out the business premises, and the floor can be used again immediately after the work is completed. This also applies to floors in storage rooms and other operational areas.
